ok next step got motor out now need to pull tranny off. HELP?

[jdmeg21]

Any hints or help with this would be great guys. I know there are 5 bolts and that I have to pry different points around the tranny case to break it loose. Just wondering if you guys had any technics or hints on getting this apart.

Also I have to transfer this tranny to another motor. so is there anything special that i need. or that I should look out for.

UPDATE 9/23/09

[isl_cruiser]

Make sure release bearing is good. And just find a good pry spot, it will just pop. Its a little nerve racking your first time

[Spens EF]

dont forget to take the starter off too

[jdmeg21]

took starter off i think that was the last thing holding it on. OK now time to swap everything to other motor. Since I'm using the clutch/fly wheel from this motor, should I have the flywheel resurfaced before putting onto the new car.

oh and thanks for everyones help. I thought this was gonna be a lot worse but has turned out to be not too hard.

[isl_cruiser]

Told ya it was nice n easy I've never gotten a flywheel machined. But if you ever pull a trans in a shop the flywheel will get turned. Its up to you, itr wont hurt to get it done.