roll fender

[aldrEK9]

i have recently installed a koni groundcontrol combo and was wondering if i should/ have to roll my fender both the front and back..

[tico_ek9]

I wouldn't

[Arthas]

For what?

[b16inside]

if youre planning on dumping it then yes but if not its a waste of money

[Nachtmensch]

only if you are rubbing...

[b16inside]

Originally Posted by Nachtmensch

only if you are rubbing...

which goes along with what i said

[sdlEF]

you can do the rear for sure but your gonna need some body work done to it since your ruining the body line when you do that. idk about the front since you don't really have a real metal on those fenders. theyre thin already plus you don't really need it in the front unless your car is really low which makes it almost impossible to drive as a DD.

[b16inside]

Originally Posted by sdlEF

you can do the rear for sure but your gonna need some body work done to it since your ruining the body line when you do that. idk about the front since you don't really have a real metal on those fenders. theyre thin already plus you don't really need it in the front unless your car is really low which makes it almost impossible to drive as a DD.

[aldrEK9]

so the tires are fine in the front even if i dont have em aligned?

[ALlTroTTle]

yes anytime you go lower you should get it aligned.....

[b16inside]

Originally Posted by aldrEK9

so the tires are fine in the front even if i dont have em aligned?

negative ghostrider
youll eat them up quick i went through a pair of azenis up front in four months because i didnt align afterwards

[Weifast]

No, unless you are going with an aggressive offset on your wheels or you are using super wide wheels. I wouldn't dump the car either. Just modestly drop it and get an alignment and you are good to go.